Please note, this configuration is not compatible with handwheels that have a rising stem.
The KPA interface is available in 3 versions:
- KPA003 for the SA003 adaptor
- KPA004 (or KPA316 stainless steel) for the SA004, SUA and FUA adaptors
- KPA005 for the SA005, SA006 and SA007 adaptors
These protectors, integrated into the self-adjusting and self-centering fingers adaptors (SAxxx), are designed to protect the handwheel from being scratched during use.
They can be built into the adaptor during assembly in the factory or added later without difficulty.
They are made from high performance polyethylene, which is anti-static and resists wear and tear. Each adaptor has a corresponding interface:
- SA103 for the SA003 adaptor
- SA104 for the SA004 adaptor
- SA105 for the SA005 adaptor
- SA106 for the SA006 adaptor
- SA107 for the SA007 adaptor
We have a wide range of extension bars which enable operators to move away from the handwheel or valve, notably in the case of tapered handwheels and underground / buried valves. Light and robust, they can be used on rising stems up to48 mm maximum diameters.
The EBX04 extension bars fix on to the FUA adaptors using the TTA interface.
The EB00X telescopic extension bars are specifically adapted for manipulating underground / buried valves. On one end they have a square ¾” male connector that connects to a standard socket. They can be activated either by a straight or right angle actuator (with the KHA001 interface, see below), or by an actuator with a banjo head (using the KHA002 interface, see below). In case the valve is deep in the ground, one can use the EB01X extensions to the telescopic EB00X.
With the KHA interface, you can manipulate the EB0xx extension bars (telescopic valve keys).
Please note, this configuration cannot be used for handwheels with a rising stem. The KHA interface is available in 3 versions:
- KHA001 for straight and right angle actuators
- KHA002 for actuators with a banjo head
- KHA003 is a universal joint for straight and right angle actuators
The KTA3/4 and TTA3/4 interfaces can take a ¾” square drive which connects to all types of socket thereby turning all kinds of screws and bolts – this makes it possible to use your actuator for various types of applications.
The KTA models should be used for actuators with a straight or right angle head.
The TTA models fix directly on to the banjo head.
A large range of standard square sockets is also available to match most of the valves standards square drives